HP JETDIRECT 170X JAVA ISSUES HOW TO SETUP A

Hp Jetdirect 170X Java Issues How To Setup A

How to control your HP Jetdirect 170x. This step by step instruction describes how to setup a HP Jetdirect 170x print server so that the 8 bits output can be controlled by a user made program or from a PHP script. To make a fresh start you can factory reset the Jetdirect 170x.

SNMPGetSet.exe, obtained here: Start the program and type the Jetdirect's IP address. This community name functions as a password, we will need it later on.Press Apply and wait for the device to reset.Now we need to change a (hardware) register inside the Jetdirect.It is the npPortCentronicsHandshaking register which controls handshaking between printer and Jetdirect.To accomplish this you need a tool that can send (and receive) SNMP commands.A simple tool will do. ).The printer status should show 'On-Line' - now you know your DB25 connector is soldered well.Click Administration and go to the Configuration tab and tick the Snmp checkbox.Enter 'private' (without the quotes) as New Set Community Name. The Jetdirect should be reset now and is configured by default to obtain an IP address automatically.Take a DB25 male connector and connect pins 1, 10, 13 and 15 together.Start your web browser and go to the Jetdirect's web interface by typing its IP address in the location bar. Press and hold the 'Test' button while plugging the power back in for 5 seconds.3.

It is retained after a power cycle.Now you are ready to control the eight bits output of your print server by PHP or any other home made program.Use TCP port 9100 to write your bytes to. The value will be written using the Write community name (top right) as password.Give the Jetdirect some time to store the new value. Copy this OID to the lower panel of the program to do a Selective SNMP Get.Click SNMP Get and note the returned value.We need to set this register value to '2'.Type '2' as value and click SNMP Set.